This week so far I have messed around a little bit more with my batch of Horizon Creation 3D bits. I liked my first attempt at fencing so I made a bunch more to start with.
|A bunch of Horizon Creations 3D bits built into fencing.|
This narrow fence support was painted exactly the same way as described in Making Mine Scenery XIV except that I chose not to go as heavy on the rust.
|My newish camera phone has a better camera yet I have a harder time getting good pictures.|
This is a top view of the new 4-way intersection. As you can see I made this one with some caution stripes for more visual interest.
This shot features another Horizon Creation 3D bit: one of the fences from their fence pack. I feel like the caution strip base is too pristine and needs to be dirtied up a bit, but I'll get to that later.
Before I wrap up I want to talk about where I am going with my current board plan. What you are looking at here are two horizontal straights, a verticle straight, a T section, two 4-way intersections, and my freight elevator. I want to be able to create flowing layouts that aren't too large that allow for a little bit of maneuvering, so at least one more 4-way intersection and either another T section or an L section should be up next to have my "basics" covered and give me greater flexibility. As always, there will be more to come!
Thanks for reading and make sure to check out Horizon Creations 3D and use the "BROKENCONTRACT" discount code if you decide to pick up anything. :)
Check out the other parts of the series:
Making Mine Scenery Part I
Making Mine Scenery Part II
Making Mine Scenery Part III
Making Mine Scenery Part IV
Making Mine Scenery Part V
Making Mine Scenery Part VI
Making Mine Scenery Part VII
Making Mine Scenery Part VIII
Making Mine Scenery Part IX
Making Mine Scenery Part X
Making Mine Scenery Part XIV